The board includes a PICtail Plus daughter card connector for expansion boards including USB, CAN, Ethernet, wireless, graphics and many more. A variety of families are supported with processor Plug-In Modules (PIMs) for easy device swapping. It supports devices from the PIC24, dsPIC and PIC32 families. The Explorer 16 Development Board is a low-cost modular development system for Microchip’s 16-bit and 32-bit microcontrollers. Afterward, the features can be enabled or disabled easily by installing or removing the jumper.
#Stage plot pro 2.9.8 serial install#
To change this, the user will need to cut the traces and install pins and a block jumper. As shipped from the factory, some of the jumper locations are bridged by circuit traces forming a default setup. When connecting to the two boards together, pay close attention to the orientation of the connector and pin alignment.Ī total of 7 jumper locations are available. Most PICDEM demonstration board do not have the female header installed, so if using a PICDEM board, a 14x2 female connector is included with this kit for the user to install onto the development board if necessary. In general, a board is compatible if it has a PICtail™ or PICtail™ Plus interface expansion port. To get started, a compatible MCU development board is required.
Microchip Technology’s firmware(AN1003) is only implemented on PICDEM™ FS USB. A complete list of compatible PICDEM™ borad is available on Microchip’s website. It is an expansion board compatible with a number of development tools for 8/16/32bit MCU’s and DSC’s. The PICtailTM Daughter Board For SD™ and MMC cards is a demonstration board for evaluating reading and writing data on SD or MMC cards.
0 kommentar(er)
